Settings

Description

Settings are non-volatile, and are loaded on power up.

When the module is put into Update Mode, the default setting values (shown in the settings table for the module) are restored.

Settings can also be set using the Boot Config File. The settings are read from the file on power-up and replace the current settings.

A description of all of the settings can be found in the Settings section of the module (uMMC, uMP3, rMP3).

Format

S setting [value]uMMC
ST setting [value]uMP3 and rMP3

Parameters

  • setting is the setting to be set/returned. See the Settings Table for the module.
  • value is the value to which setting should be set. Optional.

Response Format

NULLSuccessful
responseIf no value given, this is the current value for the setting.
EnnAn error occurred

Example

To set the bit rate to 2400 bps (on uMMC):

S D 5

To get the current bit rate (on uMP3 or rMP3):

ST D
5